Allied Telesis AT-SBX81XS6 Guía de instalación descargar pdf (Pagina 72)

Chapter 3: AT-SBx81CFC960 Controller Fabric Card

72 Section I: Hardware Overview

The NET MGMT port has a standard RJ-45 8-pin connector and operates

at 10, 100, or 1000 Mbps in either half- or full-duplex mode. The cable

requirements for this port are the same as the ports on the AT-

SBx81GT24 Line Card, given in Table 11 on page 52. For the port

pinouts, refer to “Port Pinouts” on page 311.

The default setting for the port is Auto-Negotiation, which sets the speed

and duplex mode automatically. You may disable Auto-Negotiation and

configure the port manually. The port is referred to as ETH0 in the

management software.

The wiring configuration of the NET MGMT port is set automatically with

automatic MDIX detection. You may disable automatic MDIX detection

and set the wiring configuration manually.

NET MGMT

LED

The Network Management (NET MGMT) port on the AT-SBx81CFC960

Controller Fabric Card has one Status LED, described in Table 20.

SNMPv1 and v2c Used to remotely manage the

chassis with SNMP.

SNTP client Used to set the date and time on

the controller card, from an NTP or

SNTP server on your network or

the Internet.

Syslog client Used to send the event messages

from the controller card to syslog

servers on the network.

TACACS+ client Used with a TACACS+ server on

your network for remote

management authentication.

Telnet server Used to remotely manage the

chassis with a Telnet client.

TFTP client Used to download files to or

upload files from the controller

card with TFTP.

TRACEROUTE Used to determine the

intermediate nodes (or hops) of

network paths.

Table 19. Features that Use the NET MGMT Port (Continued)

Feature Description

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 313 314

Sin comentarios

Allied Telesis AT-SBX81XS6 Guía de instalación Pagina 72