Allied Telesis AT-SBX81XS6 Guía de instalación descargar pdf (Pagina 287)

SwitchBlade x8112 Chassis Switch and AT-SBx81CFC960 Card Installation Guide

Section III: Building a Stack with VCStack Plus 287

5. After changing the ID number, enter the EXIT command to return to

the Privileged Exec mode:

awplus(config)# exit

awplus#

6. Enter the SHOW STACK command again to confirm your change.

An example of the window is shown in Figure 174 on page 288.

Table 25. Descriptions of the STACK RENUMBER Command Messages

Message Description

Warning: Stacking is currently

disabled.

This message reminds you that

even though you activated the

stacking feature with the STACK

ENABLE command in an earlier

procedure, the feature is disabled

because the chassis has not been

reset. You will reboot the switch

later in these instructions.

Warning: The new ID will not

become effective until the stack-

member reboots.

This message informs you that the

switch needs to be reset before it

begins to use its new ID number.

You will reboot the switch later in

these instructions.

Warning: The boot configuration

may now be invalid.

This message informs you that if

you have already configured

parameter settings on the switch,

some of the settings may be lost

when you reset the unit. The ID

number is used in the commands

in the configuration file to identify

the individual switch ports. When

the ID number is changed,

commands in the configuration file

that use the old ID number are no

longer valid.

1 2 ... 282 283 284 285 286 287 288 289 290 291 292 ... 313 314

Sin comentarios

Allied Telesis AT-SBX81XS6 Guía de instalación Pagina 287