
Chapter 6: Installing the Power Supplies
116 Section II: Installing the Chassis
4. Check the model name, shown in Figure 51, to verify the module.
If the module is the AT-SBxPWRSYS1 System Power Supply, do not
continue with this procedure. Instead, perform “Installing the AT-
SBxPWRSYS1 AC System Power Supply” on page 107.
Figure 51. Verifying the AT-SBxPWRPOE1 PoE Power Supply
5. Raise the locking handle on the AT-SBxPWRPOE1 Power Supply, as
shown Figure 52.
Figure 52. Unlocking the Handle on the AT-SBxPWRPOE1 Power Supply
6. Align and insert the AT-SBxPWRPOE1 Module into slot A or B. Figure
53 on page 117 shows the power supply module aligned in slot A.
The AT-SBxPWRPOE1 AC Power Supply will not work in slot C or
D.
Comentarios a estos manuales