Allied Telesis AT-SBX81XS6 Guía de instalación descargar pdf (Pagina 228)

100

101

Chapter 12: Replacing Modules

228 Section II: Installing the Chassis

Note

If the power wires are connected to the terminal block with the right

angle terminals, go to step 5.

4. Use a #1 screwdriver to loosen the two screws that secure the plastic

cover over the terminal block and slide the cover to the right. You may

need to slightly lift the locking handle to access the bottom screw.

Refer to Figure 146.

The plastic cover may not be present if you used the right angle

terminals to connect the lead wires to the terminal block. If this is the

case, you may skip this step.

Figure 146. Opening the Plastic Window over the Terminal Block

5. Use a #3 screwdriver to remove the negative (-) lead wire from the

terminal block. The negative lead wire is on the right. Refer to Figure

147 on page 229.

1 2 ... 223 224 225 226 227 228 229 230 231 232 233 ... 313 314

Comentarios a estos manuales

Sin comentarios

Allied Telesis AT-SBX81XS6 Guía de instalación Pagina 228

Comentarios a estos manuales