Allied Telesis AT-SBX81XS6 Guía de instalación descargar pdf (Pagina 154)

100

101

Chapter 8: Installing the Transceivers and Cabling the Ports

154 Section II: Installing the Chassis

Installing AT-SP10TW Cables in the AT-SBx81XS6 Line Card

This procedure explains how to connect AT-SP10TW Cables to the AT-

SBx81XS6 Line Card. The cables may be used in place of fiber optic

cables and transceivers for 10 Gbps links of up to 7 meters.

Note

The AT-SP10TW Cable is only supported in the AT-SBx81XS6 Line

Card. It is not supported in the AT-SBx81GS24a Line Card.

To install the AT-SP10TW Cable, perform the following procedure:

1. Remove the dust plug from the SFP+ slot chosen for the cable, as

shown in Figure 92.

Figure 92. Removing the Dust Cover From an SFP+ Slot in the AT-

SBx81XS6 Line Card

Note

Do not remove the dust plug from the SFP+ slot if you are not

installing the transceiver at this time. The dust plug protects the line

card from dust contamination.

2. Orient the connector on the AT-SP10TW cable so that the release tab

is on top, as shown in Figure 93 on page 155.

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 313 314

Comentarios a estos manuales

Sin comentarios

Allied Telesis AT-SBX81XS6 Guía de instalación Pagina 154

Comentarios a estos manuales