
Chapter 6: Installing the Power Supplies
118 Section II: Installing the Chassis
7. Lower the locking handle of the power supply module to secure the
module in the slot, as shown in Figure 54.
Figure 54. Locking the Handle on the AT-SBxPWRPOE1 Power Supply
8. To install a second AT-SBxPWRPOE1 Power Supply, repeat this
procedure.
9. After installing the AT-SBxPWRPOE1 Power Supplies, go to Chapter
7, “Installing the AT-SBx81CFC960 Control Card and Ethernet Line
Cards” on page 125.
Retain the tie wrap that comes with the power supply. You use it to
secure the power cord to the chassis when you power on the unit in
“Powering On the AT-SBxPWRPOE1 Power Supply” on page 168.
Comentarios a estos manuales