
Chapter 15: Building a Stack
294 Section III: Building a Stack with VCStack Plus
Figure 179. Positioning the Handle on the Transceiver
6. Connect the fiber optic cable to the transceiver, as shown in
Figure 180. The connector on the cable should fit snugly into the port,
and the tab should lock the connector into place.
Figure 180. Connecting a Fiber Optic Cable to a Stacking Transceiver
7. Repeat this procedure to cable all the stacking transceivers on both
switches. Afterwards, go to “Powering On the Stack” on page 295.
Comentarios a estos manuales