Allied Telesis AT-SBX81XS6 Guía de instalación Pagina 184

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 314
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 183
Chapter 9: Powering On the Chassis
184 Section II: Installing the Chassis
Figure 122. Connecting the Negative (-) Power Wire with a Straight
Terminal
Check to see if there are any exposed copper strands coming from
the installed wires. When this installation is done correctly there
should be no exposed copper wire strands extending from the
terminal block. Any exposed wiring can conduct harmful levels of
electricity to persons touching the wires. E12
8. Slide the plastic cover to the left and lightly tighten the two screws with
a #1 Phillips-head screwdriver to secure the cover. See Figure 123 on
page 185. You might need to lift the locking handle slightly to access
the bottom screw.
Do not over tighten the screws or you may crack or break the plastic
cover.
Vista de pagina 183
1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 313 314

Comentarios a estos manuales

Sin comentarios