
SwitchBlade x8112 Chassis Switch and AT-SBx81CFC960 Card Installation Guide
Section II: Installing the Chassis 169
3. Use the twist tie that comes with the power supply to secure the cord to
an anchor on the chassis, as shown in Figure 104.
Figure 104. Securing the Power Cord for the AT-SBxPWRPOE1 Power
Supply to an Anchor
4. Connect the power cord to an appropriate AC power source to power
on the power supply.
5. If the chassis has two AT-SBxPWRPOE1 Power Supplies, repeat this
procedure to power on the second power supply.
Figure 105 on page 170 is an illustration of the power cords for a
chassis with four power supplies.
Comentarios a estos manuales