search

Allied Telesis AT-SBX81XS6 Guía de instalación Pagina 174

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 314
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
    •
  • MARCADORES
    • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 173
Chapter 9: Powering On the Chassis
174 Section II: Installing the Chassis
3. Use an 8 mm wrench to remove the grounding post nut and washer,
shown in Figure 110, from the power supply.
Figure 110. Removing the Nut and Washer from the Grounding Post
4. Attach the grounding lug and wire to the grounding post and secure
them with the nut and washer removed in the previous step, and an 8
mm wrench.
Review the following before installing the grounding wire:
You should angle the wire to the right so that you can open the
plastic window to access the positive and negative terminals on the
terminal block.
You may route the cable either above or below the locking handle.
Allied Telesis recommends tightening the nut and washer to 26
inch-lbs.
The grounding wire is illustrated in Figure 111 on page 175.
Grounding
post
Vista de pagina 173
1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 313 314

Comentarios a estos manuales

Sin comentarios
  • Purple Line Dekpower Infinix Leica-geosystems Myron & Davis
  • JWIN Reproductores de cd Sanyo Frigoríficos Extreme Networks Módulos transceptores de red Hama No JVC Dvd Portátil / Reproductor De Blu-Ray
  • Honda GXV390 Philips HX1630 Asus F1A55-M Panasonic TXP42GT30E Konica-minolta MAXXUM 7D
  • Aluratek Cinepal APMP101F Instrucciones de operaciones Samsung T28E310EX Manual de usuario Nikon COOLPIX S5300 Manual de usuario Omron HN286 Manual de usuario Microsoft Xbox 360 Rechargeable Battery Pack Manual de usuario