
Chapter 9: Powering On the Chassis
188 Section II: Installing the Chassis
4. Using a #1 Phillips-head screwdriver, remove the two screws that
secure the plastic cover over the positive and negative terminals and
remove the plastic cover from the power supply, as shown in
Figure 127. You may need to lift the locking handle slightly to access
the bottom screw.
Figure 127. Removing the Plastic Cover
The plastic cover is not used with the right angle terminals.
5. Use a #3 Phillips-head screwdriver to remove the two screws from the
positive and negative terminals, as shown in Figure 128 on page 189.
Comentarios a estos manuales