
SwitchBlade x8112 Chassis Switch and AT-SBx81CFC960 Card Installation Guide
Section II: Installing the Chassis 161
If you are ready to attach the fiber optic cable to the transceiver,
continue with the next step. Otherwise, repeat steps 1 to 3 to install
additional SFP+ transceivers in the card.
4. Remove the protective cover from the SFP+ transceiver, as shown in
Figure 98.
Figure 98. Removing the Dust Cover from an SFP+ Transceiver in the AT-
SBx81CFC960 Controller Fabric Card
The dust cover protects the fiber optic port on the SFP+ transceiver
from dust contamination. Do not remove it until you are ready to
connect the fiber optic cable.
5. Connect the fiber optic cable to the port on the transceiver, as shown
in Figure 99 on page 162. The connector should snap into the port.
Comentarios a estos manuales