Allied Telesis AT-SBX81XS6 Guía de instalación descargar pdf (Pagina 102)

100

101

Chapter 5: Installing the Chassis in an Equipment Rack

102 Section II: Installing the Chassis

Installing the Chassis Grounding Wire

This procedure explains how to connect a grounding wire to the chassis.

The chassis requires a permanent connection for the line cards and power

supplies to a good earth ground. The procedure requires the following

items:

 Grounding lug (pre-installed on the rear panel of the chassis)

 #2 Phillips-head screwdriver (not provided)

 Crimping tool (not provided)

 10 AWG stranded grounding wire (not provided)

 #2 Phillips-head, 20 inch-lbs torque screwdriver (optional — not

provided)

To connect the chassis to an earth ground, perform the following

procedure:

1. Prepare an adequate length of stranded grounding wire (10 AWG) for

the ground connection by stripping it as shown in Figure 37.

Figure 37. Stripping the Grounding Wire

2. Remove the two screws that secure the grounding lug to the rear

panel of the chassis, as shown in Figure 38.

Figure 38. Removing the Grounding Lug

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 313 314

Comentarios a estos manuales

Sin comentarios

Allied Telesis AT-SBX81XS6 Guía de instalación Pagina 102

Comentarios a estos manuales