Chapter 8: Installing the Transceivers and Cabling the Ports
158 Section II: Installing the Chassis
This setting is appropriate for port if it is connected to a network
device that also support the feature.
The default wiring configuration of automatic MDIX detection is not
appropriate for the NET MGMT port if it is connected to a network
device that does not support the feature. You should disable
automatic MDIX detection and set the wiring configuration
manually with the POLARITY command.
After cabling the NET MGMT port, do one of the following:
To install and cable additional transceivers, go to the appropriate
section in this chapter for instructions.
After cabling all the ports in the chassis, go to Chapter 9,
“Powering On the Chassis” on page 163.
Comentarios a estos manuales