Allied-telesis AT-S94 CLI (AT-8000S Series) Manual de usuario Pagina 329

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 402
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 328
System Management Commands
Page 328
Default Configuration
The automatically configured unit number is assigned.
Command Modes
Global Configuration mode
User Guidelines
This command is not relevant to standalone devices.
The command takes effect only after resetting the device.
Example
This example changes Unit Number 6 to Unit Number 5. The command takes effect only after resetting the device.
show stack
Note
This command is operational in the AT-S94/24, AT-S94/24POE, AT-S94/48 and AT-S94/48POE devices.
The show stack User EXEC mode command displays information about the status of a stack.
Syntax
show stack [unit unit]
Parameters
unit— Specifies the number of the unit. (Range: 1-6)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
This command is not relevant to standalone devices.
Example
The following example displays stack status.
console#
config
console(config)#
stack change unit-id
6
to
5
console>
show stack
Unit MAC Address Software Master Uplink Downlink Status
Vista de pagina 328
1 2 ... 324 325 326 327 328 329 330 331 332 333 334 ... 401 402

Comentarios a estos manuales

Sin comentarios