Allied-telesis AT-S94 CLI (AT-8000S Series) Manual de usuario Pagina 30

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 402
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 29
Page 29
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface Users Guide
Default Configuration
No IPv4 Access List is defined.
Command Mode
IP Access-list Configuration mode
User Guidelines
Enter IP-Access List configuration mode by using the ip access-list Global Configuration mode command.
After an access control entry (ACE) is added to an access control list, an implied deny-any-any condition
exists at the end of the list. That is, if there are no matches, the packets are denied. However, before the first
ACE is added, the list permits all packets.
Example
The following example defines a permit statement for an IP ACL.
ipv6 access-list
The ipv6 access-list Global Configuration mode command defines an IPv6 Access List and places the device in
IPv6 Access List Configuration mode. Use the no form of this command to remove the Access List.
Syntax
ipv6 access-list access-list-name
no ipv6 access-list access-list-name
Parameters
access-list-name — Name of the IPv6 Access List. (Range: 1 - 32 characters)
General Routing Encapsulation gre 47
Encapsulating Security Payload (50)
esp 50
Authentication Header ah 51
ICMP for IPv6 ipv6-icmp 58
EIGRP routing protocol eigrp 88
Open Shortest Path Protocol ospf 89
Protocol Independent Multicast pim 103
Layer Two Tunneling Protocol l2tp 115
ISIS over IPv4 isis 124
(any IP protocol) any 25504
console(config)#
ip-access-list
ip-acl1
console(config-ip-al)#
deny
rsvp 192.1.1.1 0.0.0.255
any
IP Protocol Abbreviated Name Protocol Number
Vista de pagina 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 401 402

Comentarios a estos manuales

Sin comentarios