Allied-telesis AT-S94 CLI (AT-8000S Series) Manual de usuario descargar pdf (Pagina 176)

100

101

Page 175

Allied Telesis

AT-8000S-S94-3.0 Command Line Interface User’s Guide

Default Configuration

Enabled in both modes.

Command Modes

Interface Configuration (Ethernet) mode.

User Guidelines

•

LLDP manages LAG ports individually. LLDP sends separate advertisements on each port in a LAG. LLDP

data received through LAG ports is stored individually per port.

• An LLDP operation on a port is not dependent on the STP state of a port. This means that LLDP frames are

sent and received on blocked ports. If a port is controlled by 802.1X, LLDP operates only if the port is

authorized.

Examples

The following example enables LLDP on an interface.

lldp timer

The lldp timer command Global Configuration mode command specifies how often the system sends LLDP

updates. Use the no form of this command to revert to the default setting.

Syntax

lldp timer seconds

no lldp timer

Parameters

•

seconds — Specifies, in seconds, how often the software sends an LLDP update. (Range: 5 - 32768

seconds)

Default Configuration

The default value is 30 seconds.

Command Modes

Global Configuration mode.

User Guidelines

There are no user guidelines for this command.

Example

The following example specifies the system to send LLDP updates every 50 seconds.

console(config)# interface ethernet e5

console(config-if)# lldp enable

console(config) # lldp timer 50

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 401 402

Comentarios a estos manuales

Sin comentarios

Allied-telesis AT-S94 CLI (AT-8000S Series) Manual de usuario Pagina 176

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Allied-telesis AT-S94 CLI (AT-8000S Series)