Allied-telesis AT-S94 CLI (AT-8000S Series) Manual de usuario descargar pdf (Pagina 32)

Page 31

Allied Telesis

AT-8000S-S94-3.0 Command Line Interface User’s Guide

Parameters

•

destination-port — Specifies the UDP/TCP destination port. (Range: 0- 65535)

• destination-prefix/length — The destination IPv6 network or class of networks about which to set permit

conditions. This argument must be in the form documented in RFC 3513, where the address is specified in

hexadecimal using 16-bit values between colons.

• dscp number — Matches a differentiated services codepoint value against the traffic class value in the Traffic

Class field of each IPv6 packet header. (Range: 0 - 63)

• flags list-of-flags — List of TCP flags that should occur. If a flag should be set, it is prefixed by +. If a flag

should be unset it is prefixed by -. Avaiable options are +urg, +ack, +psh, +rst, +syn, +fin, -urg, -ack, -psh,

-rst, -syn and -fin. The flags are concatenated to one string. For example: +fin-ack.

• icmp-type — Specifies an ICMP message type for filtering ICMP packets. Enter a number or one of the

following values: destination-unreachable, packet-too-big, time-exceeded, parameter-problem, echo-

request, echo-reply, mld-query, mld-report, mldv2-report, mld-done, router-solicitation, router-

advertisement, nd-ns, nd-na. (Range: 0 - 255)

• icmp-code — Specifies an ICMP message code for filtering ICMP packets. (Range: 0 - 255)

• ip-precedence number — Specifies the IP precedence value.

• protocol — The name or the number of an IP protocol. Available protocol names are: icmp, tcp and udp.

(Range: 0 - 255)

• destination-port — Specifies the UDP/TCP destination port. (Range: 1 - 65535)

• source-port — Specifies the UDP/TCP source port. (Range: 1 - 65535)

• source-prefix/length — The source IPv6 network or class of networks about which to set permit conditions.

This argument must be in the form documented in RFC 3513, where the address is specified in hexadecimal

using 16-bit values between colons.

Default Configuration

No IPv6 access list is defined.

Command Mode

IPv6 access list configuration

IP Protocol Abbreviated Name Protocol Number

Transmission Control Protocol tcp 6

User Datagram Protocol udp 17

Internet Control Message Protocol icmp 58

(any IP protocol) any 25504

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 401 402

Sin comentarios

Allied-telesis AT-S94 CLI (AT-8000S Series) Manual de usuario Pagina 32