Allied-telesis AT-S94 CLI (AT-8000S Series) Manual de usuario descargar pdf (Pagina 181)

LLDP Commands

Page 180

Syntax

lldp med enable [tlv1 … tlv3]

no lldp med enable

Parameters

•

tlv — Specifies the TLV that should be included. Available TLVs are: network-policy, location and poe-pse.

The TLV capabilities are always included if LLDP MED is enabled.

Default Configuration

LLDP MED is disabled.

Command Mode

Interface Configuration (Ethernet) mode.

User Guidelines

There are no user guidelines for this command.

Example

The following example enables LLDP MED on an interface as network-policy.

lldp med network-policy (global)

The lldp med network-policy Global Configuration mode command defines LLDP MED network policy. Use the

no form of this command to remove LLDP MED network policy.

Syntax

lldp med network-policy number application [vlan id] [vlan-type {tagged|untagged}] [up priority] [dscp value]

no lldp med network-policy number

Parameters

•

number — Network policy sequential number.

• application — The name or the number of the primary function of the application defined for this network

policy. Available application names are: voice, voice-signaling, guest-voice, guest-voice-signaling,

softphone-voice, video-conferencing, streaming-video and video-signaling.

• vlan id — VLAN identifier for the application.

• vlan-type — Specifies if the application is using a tagged or an untagged VLAN.

• up priority — User Priority (Layer 2 priority) to be used for the specified application.

• dscp value — DSCP value to be used for the specified application.

Default Configuration

No Network policy is defined.

console(config)# interface ethernet e5

console(config-if)# lldp med enable network-policy

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 401 402

Sin comentarios

Allied-telesis AT-S94 CLI (AT-8000S Series) Manual de usuario Pagina 181