Allied-telesis SwitchBlade x8106 Manual de usuario descargar pdf (Pagina 212)

Chapter 10: Replacing Modules

212

Note

If the power wires are connected to the terminal block with the right

angle terminals, go to step 5.

4. Use a #1 screwdriver to loosen the two screws that secure the plastic

cover over the terminal block and slide the cover to the right. You may

need to slightly lift the locking handle to access the bottom screw.

Refer to Figure 143.

The plastic cover may not be present if the lead wires are connected to

the terminal block with the right angle terminals. If this is the case, you

may skip this step.

Figure 143. Opening the Plastic Window on the Terminal Block

5. Use a #3 screwdriver to remove the negative (-) lead wire from the

terminal block. The negative lead wire is on the right. Refer to Figure

144 on page 213.

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 239 240

Sin comentarios

Allied-telesis SwitchBlade x8106 Manual de usuario Pagina 212