Allied-telesis SwitchBlade x8106 Manual de usuario descargar pdf (Pagina 138)

Chapter 6: Installing the Transceivers and Cabling the Ports

138

Installing AT-SP10TW Cables in the AT-SBx81XS6 Line Card

This procedure explains how to connect AT-SP10TW Cables to the AT-

SBx81XS6 Line Card. The cables may be used in place of fiber optic

cables and transceivers for 10 Gbps links of up to 7 meters.

Note

The AT-SP10TW Cable is only supported in the AT-SBx81XS6 Line

Card. It is not supported in the AT-SBx81GS24a Line Card.

To install the AT-SP10TW Cable, perform the following procedure:

1. Remove the dust plug from the SFP+ slot chosen for the cable, as

shown in Figure 94.

Figure 94. Removing the Dust Cover From an SFP+ Slot in the AT-

SBx81XS6 Line Card

Note

Do not remove the dust plug from the SFP+ slot if you are not

installing the transceiver at this time. The dust plug protects the line

card from dust contamination.

2. Orient the connector on the AT-SP10TW cable so that the release tab

is on top, as shown in Figure 95 on page 139.

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 239 240

Sin comentarios

Allied-telesis SwitchBlade x8106 Manual de usuario Pagina 138