Allied-telesis SwitchBlade x8106 Manual de usuario descargar pdf (Pagina 154)

Chapter 7: Powering On the Chassis

154

3. Use an 8 mm wrench to remove the grounding post nut and washer,

shown in Figure 107, from the power supply.

Figure 107. Removing the Nut and Washer from the Grounding Post

4. Attach the grounding lug and wire to the grounding post and secure

them with the nut and washer removed in the previous step, and an 8

mm wrench.

Review the following before installing the grounding wire:

 You should angle the wire to the right so that you can open the

plastic window to access the positive and negative terminals on the

terminal block.

 You may route the cable either above or below the locking handle.

The grounding wire is illustrated in Figure 108 on page 155.

Grounding

post

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 239 240

Sin comentarios

Allied-telesis SwitchBlade x8106 Manual de usuario Pagina 154