Allied-telesis SwitchBlade x8106 Manual de usuario descargar pdf (Pagina 206)

Chapter 10: Replacing Modules

206

Replacing AT-SBxPWRSYS1 AC and AT-SBxPWRPOE1 Power

Supplies

This section contains the procedure for removing AT-SBxPWRSYS1 AC

and AT-SBxPWRPOE1 Power Supplies from the AT-SBx8106 Chassis.

Note

The illustrations in the following procedure show the removal of an

AT-SBxPWRSYS1 AC Power Supply from slot D. The procedure is

the same for all power supply slots.

To remove an AT-SBxPWRSYS1 AC or AT-SBxPWRPOE1 Power Supply

from the chassis, perform the following procedure:

1. Disconnect the AC power cord for the power supply from the AC

power source and the corresponding AC socket on the back panel of

the chassis. The figure in Figure 137 shows the removal of the power

cord from connector D, which corresponds to slot D on the front panel.

Figure 137. Disconnecting the AC Power Cord from the AC Socket on the

Back Panel

1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 239 240

Sin comentarios

Allied-telesis SwitchBlade x8106 Manual de usuario Pagina 206