Allied-telesis SwitchBlade x8106 Manual de usuario descargar pdf (Pagina 115)

SwitchBlade x8106 Chassis Switch Installation Guide

115

Figure 71. Aligning the AT-SBx81CFC400 Card in the Chassis Slot

7. Slowly and carefully slide the card into the slot.

Caution

Keep the card level with the chassis as you slide it into the slot. You

might damage the components on the top or bottom of the card if

you slide it in at an angle. Refer to Table 65 on page 111.

Caution

Do not force the AT-SBx81CFC400 Card into the slot. If you feel

resistance, remove it and try again. Be sure that the edges of the

card are properly aligned with the card guides.

8. When you feel the card make contact with the connector on the

backplane of the chassis, carefully close the two locking levers on the

front panel of the controller card to secure it in the chassis, as shown in

Figure 72 on page 116.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 239 240

Sin comentarios

Allied-telesis SwitchBlade x8106 Manual de usuario Pagina 115