Allied-telesis SwitchBlade x8106 Manual de usuario descargar pdf (Pagina 112)

Chapter 5: Installing the AT-SBx81CFC400 Controller and Ethernet Line Cards

112

Installing the AT-SBx81CFC400 Controller Fabric Card

This section contains the installation procedure for the AT-SBx81CFC400

Controller Fabric Card. You may install either one or two controller cards

in the unit. The chassis must have at least one controller card. The cards

must be installed in slots 5 and 6 in the chassis.

Note

Please review “Guidelines to Handling the Controller and Line

Cards” on page 110 before performing this procedure:

This procedure requires the following tools:

 #2 Phillips-head screwdriver (not provided)

 #2 Phillips-head, 5 inch-lbs torque screwdriver (optional — not

provided))

To install the AT-SBx81CFC400 Card, perform the following procedure:

1. Choose a slot in the chassis for the AT-SBx81CFC400 Controller

Fabric Card.

The card must be installed in slot 5 or 6, shown in Figure 66. If you are

installing only one controller card, Allied Telesis recommends installing

it in slot 5.

Figure 66. Slots 5 and 6 for the AT-SBx81CFC400 Card

2. Remove the new AT-SBx81CFC400 Control Card from the shipping

package and verify the package contents, listed in Table 67 on

page 113.

If any item is missing or damaged, contact your Allied Telesis sales

representative for assistance.

Slot 5

Slot 6

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 239 240

Sin comentarios

Allied-telesis SwitchBlade x8106 Manual de usuario Pagina 112