Allied-telesis AT-S95 CLI Manual de usuario descargar pdf (Pagina 98)

Page 86

Not approved by Document Control. For review only.

Allied Telesis

Command Line Interface User’s Guide

Example

The following example configures the duplex operation of Ethernet port 1/g5 to full duplex operation.

negotiation

The negotiation Interface Configuration (Ethernet, port-channel) mode command enables auto-negotiation

operation for the speed and duplex parameters of a given interface. Use the no form of this command to disable

auto-negotiation.

Syntax

negotiation [capability1 [capability2…capability5]]

no negotiation

Parameters

•

capability — Specifies the capabilities to advertise. (Possible values: 10h, 10f, 100h,100f, 1000f)

Default Configuration

Auto-negotiation is enabled.

If unspecified, the default setting is to enable all capabilities of the port.

Command Mode

Interface Configuration (Ethernet, port-channel) mode

User Guidelines

If capabilities were specified when auto-negotiation was previously entered, not specifying capabilities when

currently entering auto-negotiation overrides the previous configuration and enables all capabilities.

Example

The following example enables auto-negotiation on Ethernet port 1/g5.

flowcontrol

The flowcontrol Interface Configuration (Ethernet, port-channel) mode command configures flow control on a

given interface. Use the no form of this command to disable flow control.

Syntax

flowcontrol {on | off | auto}

no flowcontrol

Console(config)#

interface ethernet 1/g5

Console(config-if)#

duplex full

Console(config)#

interface ethernet 1/g5

Console(config-if)#

negotiation

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 347 348

Sin comentarios

Allied-telesis AT-S95 CLI Manual de usuario Pagina 98