
Page 18
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Default Configuration
No IPv4 Access List is defined.
Command Mode
IP Access-list Configuration mode
User Guidelines
•
Enter IP-Access List configuration mode by using the ip access-list Global Configuration mode command.
• After an access control entry (ACE) is added to an access control list, an implied deny-any-any condition
exists at the end of the list. That is, if there are no matches, the packets are denied. However, before the first
ACE is added, the list permits all packets.
Example
The following example shows how to define a permit statement for an IP ACL.
mac access-list
The mac access-list Global Configuration mode command defines a Layer 2 Access List and places the device in
MAC-Access List Configuration mode. Use the no form of this command to remove the Access List.
Ipv6 protocol ipv6 41
Routing Header for IPv6 ipv6-route 43
Fragment Header for IPv6 ipv6-frag 44
Inter-Domain Routing Protocol
idrp 45
Reservation Protocol rsvp 46
General Routing Encapsulation gre 47
Encapsulating Security Payload (50)
esp 50
Authentication Header ah 51
ICMP for IPv6 ipv6-icmp 58
EIGRP routing protocol eigrp 88
Open Shortest Path Protocol ospf 89
Protocol Independent Multicast pim 103
Layer Two Tunneling Protocol l2tp 115
ISIS over IPv4 isis 124
(any IP protocol) any 25504
Console(config)#
ip-access-list
ip-acl1
Console(config-ip-al)#
deny
rsvp 192.1.1.1 0.0.0.255
any
IP Protocol Abbreviated Name Protocol Number
Comentarios a estos manuales