Allied-telesis AT-S95 CLI Manual de usuario descargar pdf (Pagina 300)

Page 288

Not approved by Document Control. For review only.

Allied Telesis

Command Line Interface User’s Guide

Example

This example configures ethernet port 1/g8 as a protected port, so that all traffic is sent to its uplink (ethernet port

1/g9).

switchport mode

The switchport mode Interface Configuration mode command configures the VLAN membership mode of a port.

Use the no form of this command to return to the default configuration.

Syntax

switchport mode {access | trunk | general}

no switchport mode

Parameters

•

access — Indicates an untagged layer 2 VLAN port.

• trunk — Indicates a trunking layer 2 VLAN port.

• general — Indicates a full 802-1q supported VLAN port.

Default Configuration

All ports are in access mode, and belong to the default VLAN (whose VID=1).

Command Mode

Interface Configuration (Ethernet, port-channel) mode

User Guidelines

There are no user guidelines.

Example

The following example configures Ethernet port 1/g16 as an untagged layer 2 VLAN port.

Console(config)#

interface ethernet 1/g8

Console(config-if)#

switchport forbidden vlan add 234-256

Console(config-if)#

exit

Console(config)#

interface ethernet 1/g9

Console(config-if)#

switchport protected ethernet 1/g1

Console(config)# interface ethernet 1/g16

Console(config-if)# switchport mode

access

1 2 ... 295 296 297 298 299 300 301 302 303 304 305 ... 347 348

Sin comentarios

Allied-telesis AT-S95 CLI Manual de usuario Pagina 300