
Page 88
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Example
In the following example, automatic crossover is enabled on port 1/g5.
back-pressure
The back-pressure Interface Configuration (Ethernet, port-channel) mode command enables back pressure on a
given interface. Use the no form of this command to disable back pressure.
Syntax
back-pressure
no back-pressure
Default Configuration
Back pressure is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
In the following example back pressure is enabled on port 1/g5.
port jumbo-frame
The port jumbo-frame Global Configuration mode command enables jumbo frames for the device. Use the no
form of this command to disable it.
Syntax
port jumbo-frame
no port jumbo-frame
Default Configuration
Disabled.
Command Mode
Global Configuration mode.
Console(config)#
interface ethernet 1/g5
Console(config-if)#
mdix
auto
Console(config)#
interface ethernet 1/g5
Console(config-if)# back-pressure
Comentarios a estos manuales