Allied-telesis AT-S95 CLI Manual de usuario descargar pdf (Pagina 274)

Page 262

Not approved by Document Control. For review only.

Allied Telesis

Command Line Interface User’s Guide

Chapter 28.System Management Commands

ping

The ping User EXEC mode command sends ICMP echo request packets to another node on the network.

Syntax

ping {ip-address | hostname } [size packet_size] [count packet_count] [timeout time_out]

Parameters

•

ip-address — IP address to ping.

• hostname — Host name to ping. (Range: 1-158 characters)

• packet_size — Number of bytes in a packet. The actual packet size is eight bytes larger than the specified

size specified because the device adds header information. (Range: 56 - 1472 bytes)

• packet_count — Number of packets to send. If 0 is entered, it pings until stopped. (Range: 0-65535 packets)

• time_out — Timeout in milliseconds to wait for each reply. (Range: 50 - 65535 milliseconds)

Default Configuration

Default packet size is 56 bytes.

Default number of packets to send is 4.

Default timeout value is 2000 milliseconds.

Command Mode

User EXEC mode

User Guidelines

•

The hostname must be a fully qualified DNS name. A fully qualified DNS name has a period at the end.

• Press Esc to stop pinging.

• Following are examples of unsuccessful pinging:

– Destination does not respond. If the host does not respond, a “no answer from host” appears in ten

seconds.

– Destination unreachable. The gateway for this destination indicates that the destination is unreachable.

– Network or host unreachable. The device found no corresponding entry in the route table.

1 2 ... 269 270 271 272 273 274 275 276 277 278 279 ... 347 348

Sin comentarios

Allied-telesis AT-S95 CLI Manual de usuario Pagina 274