Allied-telesis AT-S95 CLI Manual de usuario Pagina 280

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 348
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 279
Page 268
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Syntax
show stack [unit unit]
Parameters
unit— Specifies the number of the unit. (Range: 1-6)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
This command is not relevant to standalone devices.
Example
The following example displays stack status..
Console>
show stack
Unit MAC Address Software Master Uplink Downlink Status
---- ----------------- -------- -------- ------ -------- ------
1 00:15:77:74:64:40 v1.1.0.23 Enabled 2 3 Master
2 00:15:77:66:3e:80 v1.1.0.23 Enabled 3 1 Backup
3 00:01:02:03:04:05 v1.1.0.23 Disabled 1 2 Slave
Topology is Ring
Unit Unit Id After Reset
----
-------------
11
2
2
3
3
console#
show stack
1
Unit: 1
MAC address: 00:15:77:74:64:40
Master: Enabled.
Product: AT -S94/48. Software: v1.1.0.23
Uplink unit: 2 Downlink unit: 3.
Status: Master
Active image: image-2.
Selected for next boot: image-2.
Vista de pagina 279
1 2 ... 275 276 277 278 279 280 281 282 283 284 285 ... 347 348

Comentarios a estos manuales

Sin comentarios