Allied-telesis AT-S95 CLI Manual de usuario descargar pdf (Pagina 278)

Page 266

Not approved by Document Control. For review only.

Allied Telesis

Command Line Interface User’s Guide

Command Mode

Global Configuration mode

User Guidelines

This command is not relevant to standalone devices.

The following algorithm is used to select a unit as the master:

• If only one master-enabled unit is in the stack (1 or 2), it becomes the master.

• If a unit configured as a forced master, it becomes the master.

If a forced master unit is removed from a stack and placed in a different stack with another forced master unit, both

are considered to be forced, and the election criteria continue as follows:

• The unit with the longer up-time is elected master. Units are considered to have the same up-time if they were

powered up within ten minutes of each other.

• If both forced master units have the same up-time, Unit 1 is elected.

Example

The following example selects Unit 2 as the stack master.

stack reload

Note

This command is operational in the AT-S94/24, AT-S94/24POE, AT-S94/48 and AT-S94/48POE devices.

The stack reload Privileged EXEC mode command reloads stack members.

Syntax

stack reload [unit unit]

Parameters

•

unit— Number of the unit to be reloaded (Range: 1-6)

Default Configuration

All units are reloaded.

Command Modes

Privileged EXEC mode

User Guidelines

This command is not relevant to standalone devices.

If no unit is specified, all units are reloaded.

Console(config)#

stack master unit

1 2 ... 273 274 275 276 277 278 279 280 281 282 283 ... 347 348

Sin comentarios

Allied-telesis AT-S95 CLI Manual de usuario Pagina 278