Allied-telesis AT-S95 CLI Manual de usuario descargar pdf (Pagina 299)

VLAN Commands

Page 287

Parameters

•

string — Unique name to be associated with this VLAN. (Range: 1-32 characters)

Default Configuration

No name is defined.

Command Mode

Interface Configuration (VLAN) mode. Cannot be configured for a range of interfaces (range context).

User Guidelines

There are no user guidelines for this command.

Example

The following example gives VLAN number 19 the name Marketing.

switchport protected

The switchport protected Interface Configuration mode command enables Private VLAN Edge, by overriding the

FDB decision, and sends all Unicast, Multicast and Broadcast traffic to an uplink port. Use the no form of this

command to disable overriding the FDB decisiond.

Syntax

switchport protected {ethernet port | port-channel port-channel-number }

no switchport protected

Parameters

•

port— Specifies the uplink Ethernet port.

• port-channel-number — Specifies the uplink port-channel.

Default Configuration

Switchport protected is disabled.

Command Mode

Interface Configuration (Ethernet, port-channel) mode

User Guidelines

Private VLAN Edge (PVE) supports private communication by isolating PVE-defined ports and ensuring that all

Unicast, Broadcast and Multicast traffic from these ports is only forwarded to uplink port(s).

PVE requires only one VLAN on each device, but not on every port; this reduces the number of VLANs required

by the device. Private VLANs and the default VLAN function simultaneously in the same device.

The uplink must be a GE port.

Console(config)# interface vlan 19

Console(config-if)# name Marketing

1 2 ... 294 295 296 297 298 299 300 301 302 303 304 ... 347 348

Sin comentarios

Allied-telesis AT-S95 CLI Manual de usuario Pagina 299