
WAN Load Balancing reset wanlb resource 1-27
Software Version 2.7.5
C613-10454-00 REV A
reset wanlb resource
Syntax RESET WANLB RESource={ALL|interface}
Description This command resets states of the specified wan load balancer resource. A reset
is equivalent to the disable wanlb resource command on page 1-22,
immediately followed by the enable wanlb resource command on page 1-26.
Examples To reset the states of all of the resources currently configured on a router, use
the command:
reset wanlb res=all
Related Commands reset wanlb resource counter
show wanlb resource
Parameter Description
interface The resource whose states are to be reset. Interface is a valid interface
name formed by concatenating an interface type and an interface
instance. Valid interfaces are:
● eth (such as eth0, eth1)
● PPP (such as ppp0, ppp1)
To see a list of current valid interfaces, use the show interface
command.
ALL Resets the state of all wan load balancer interfaces and counters.
Comentarios a estos manuales