
1-24 enable wanlb debug Release Note
Software Version 2.7.5
C613-10454-00 REV A
enable wanlb debug
Syntax ENAble WANLB
DEBug[={ALL|ABD|HEALthcheck|IP|RESource|SELect}]
Description This command enables debugging on the WAN load balancer.
Caution: Enabling WAN load balancer debugging may affect packet
forwarding performance.
Examples To enable WAN load balancer debug, use the command:
ena wanlb deb
Related Commands disable wanlb debug
show wanlb debug
Parameter Description
DEBug Enables WAN load balancer debugging
ABD Displays information about Adaptive Bandwidth
Detection calculations, such as the observed resource
throughput and updates to the resource weight.
HEALthcheck Displays information about the reception and
transmission of healthcheck packets, the average
response time, and any changes in whether
healthcheck hosts are reachable.
IP Displays information about the creation of new
WAN
load balancer
sessions for new IP flows.
RESource Displays any state changes that occur for
WAN load
balancer
resources.
SELect Displays how resource selection for new
WAN load
balancer
sessions is determined
ALL Enables all types of debugging
Comentarios a estos manuales