Allied-telesis AT-SBx81CFC960 Manual de usuario descargar pdf (Pagina 300)

Chapter 15: Building a Stack

300 Section III: Building a Stack with VCStack Plus

Installing and Cabling the Stacking Transceivers

For background information on the stacking transceivers, refer to “Stack

Trunk and Stacking Transceivers” on page 271. For background

information on the cabling configurations, refer to “Cabling Configurations

for the Stacking Transceivers” on page 273.

To install the stacking transceivers in the SFP+ slots on the controller

cards of the two chassis, perform the following procedure:

1. Remove the dust cover from one of the SFP+ slots on the AT-

SBx81CFC960 Controller Fabric Card. Refer to Figure 188.

Figure 188. Removing the Dust Cover from an SFP+ Slot on the AT-

SBx81CFC960 Controller Fabric Card

2. Orient the stacking transceiver with the handle on top if you are

installing it in slot 1 or 3, or with the handle on the bottom for slot 2 or

4. Refer to Figure 189.

Figure 189. Handle on the AT-StackOP/0.3 and AT-StackOP/9.0

Transceivers

3. Slide the transceiver into the slot until it clicks into place. Refer to

Figure 190 on page 301.

Handle

1 2 ... 295 296 297 298 299 300 301 302 303 304 305 ... 321 322

Sin comentarios

Allied-telesis AT-SBx81CFC960 Manual de usuario Pagina 300