Allied-telesis AT-SBx81CFC960 Manual de usuario descargar pdf (Pagina 145)

SwitchBlade x8106 Chassis Switch and AT-SBx81CFC960 Card Installation Guide

Section II: Installing the Chassis 145

 The default wiring configuration of the ports is automatic MDIX

detection, which configures the MDI/MDIX setting automatically.

This setting is appropriate for switch ports that are connected to

network devices that also support the feature.

 The default wiring configuration of automatic MDIX detection is not

appropriate for ports that are connected to network devices that do

not support the feature. On those ports, you should disable

automatic MDIX detection and set the wiring configuration

manually with the POLARITY command.

Connecting

Cables to the AT-

SBx81GT40 Line

Card

Here are a few additional guidelines to connecting cables to ports on the

AT-SBx81GT40 Line Card:

 The ports require the RJ point 5 cable connector shown in Figure 83.

Figure 83. RJ Point 5 Cable Connector for AT-SBx81GT40 Line Card

 To connect a cable to a port in the top role on the line card, orient the

connector with the release tab on top. To connect a cable to a port in

the bottom role, orient the connector with the release tab on the

bottom. Refer to Figure 84 on page 146.

 To remove a cable from a port, pull gently on the release tab and slide

the cable connector from the port.

Note

Patch cables for the AT-SBx81GT40 Line Card, in lengths of 1 meter

and 3 meters with RJ point 5 and RJ-45 connectors, are available

from Allied Telesis. Contact your Allied Telesis sales representative

for information.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 321 322

Sin comentarios

Allied-telesis AT-SBx81CFC960 Manual de usuario Pagina 145