Allied-telesis AT-SBx81CFC960 Manual de usuario descargar pdf (Pagina 298)

Chapter 15: Building a Stack

298 Section III: Building a Stack with VCStack Plus

Powering Off the Chassis

Now that you have configured the chassis, you should power it off. To

power off the unit, do one of the following:

 If the chassis has the AT-SBxPWRSYS1 AC and AT-

SBxPWRPOE1 PoE power supplies, disconnect the AC power

cords from the connectors on the back panel of the unit or from the

power sources.

 If the unit has the AT-SBxPWRSYS1 DC power supply, turn the

power switch on the power supply to off. Refer to Figure 62 on

page 124.

Be sure to power off all the power supplies in the chassis.

After powering off the chassis, do one of the following:

 To configure the second chassis, go to “Configuring the Second

Chassis” on page 299

 If you are finished configuring both chassis, go to “Installing and

Cabling the Stacking Transceivers” on page 300.

Note

Powering off the chassis to install the stacking transceivers is

optional. The transceivers are hot-swappable and can be installed

while the chassis is powered on. However, Allied Telesis

recommends that both chassis be powered off when you power on

the stack for the first time.

Note

If you decide not to power off the chassis, you must reset both units

with the REBOOT command in the Privileged Exec mode after

installing the stacking transceivers in “Installing and Cabling the

Stacking Transceivers” on page 300.

1 2 ... 293 294 295 296 297 298 299 300 301 302 303 ... 321 322

Sin comentarios

Allied-telesis AT-SBx81CFC960 Manual de usuario Pagina 298