Allied Telesis AT-iMG606BD Especificaciones descargar pdf (Pagina 908)

100

101

16. Setting Up Fault Management Configuring Event Parsers

899

AlliedView NMS Administration Guide

If the event object contains the trap pdu information, you can make use of the trap pdu information while defining the output

events. The methodology of using the properties of the trap using symbolic notations is similar as in Trap Parsers, except for

the following:.

• To access the values of the SNMP OID in the SNMP Variable bindings, the notation should start with % and not with $ as

in trap parser.

• To access the SNMP OID in the SNMP Variable bindings, the notation should start with @ which is same as in trap

parser.

The values of the trap pdu can be used in any of the columns, except in Tokenizer in the parser defined.

Note: If the trap pdu symbolic notation, such as %Agent, is used in the property column (while configuring Additional Criteria) when

the value has also been tokenized by specifying a tokenizer string, then to refer to a token of this field use the notation as

$%Agent$N, where N specifies the count of the token to be used.

16.4.2 Relationship Between User Properties and Custom Views

As explained in Table 16-4, user properties can be added using the Event Parser form and clicking the More button. (They

can also be added by Allied Telesis software extensions.) These can then be used in additional event event parsers or custom

views

Note: When defining properties for nodes, include the properties displayed on the last page of the Managed Object Properties Form.

For Event Custom Views, refer to the NMS User Guide, Section 9.

For Alarm Custom Views, refer to the NMS User Guide, Section 9. Note that for custom alarm views only one user

property, sysLocation, is available. This is explained in the User Guide.

16.4.3 Setting up a SYSLOG Event to Create an Alarm

By using the Event Parser Configurator, the user can parse a SYSLOG event so that an alarm is produced. This can be useful

if certain events, such as a configuration change on the a device, need to be highlighted.

Figure 16-5 shows how a SYSLOG that includes the string “Configuration Updated” can be set. The user would bring up the

Event Parser Configuration window and Add Event Parser, in this case ConfigChangeSyslogParser. The Category is SYSLOG,

and the Severity for the Output String is Major. (SYSLOG events have no severity level on the Match String and so the

Severity is set to All.)

1 2 ... 903 904 905 906 907 908 909 910 911 912 913 ... 994 995

Comentarios a estos manuales

Sin comentarios

Allied Telesis AT-iMG606BD Especificaciones Pagina 908

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores Allied Telesis AT-iMG606BD