Allied Telesis AT-iMG606BD Especificaciones descargar pdf (Pagina 636)

100

101

14. Provisioning the iMG/RG Provisioning Strategy

627

AlliedView NMS Administration Guide

FIGURE 14-4 iMG7x6MOD Configuration

14.1.3 Provisioning Strategies

The main tasks involved in provisioning the iMG/RG are:

1. Setting up the DHCP configuration. This is done on DHCP server(s) and iMAPs, and is done at initial iMAP installation.

2. Creating Profiles. This is done upon initial setup of the iMAPs that participate in the Access Island.

Note: Items 1 and 2 only need to be done once. The remaining tasks are done for each customer using an iMG/RG.

3. Provisioning the Triple Play form

4. Installing the RG

5. Applying power to the RG and waiting for key indicators (lights) for when the RG is configured and running (initial and

reboot sequence)

6. Attaching the customer devices

7. Setting up Custom Views to help in viewing the RG configuration.

8. Updating of configuration (usually done through AlliedView NMS applications)

The order of these tasks depends on which overall strategy the network administrator wishes to follow:

1. Fill in the Triple Play form before applying power to the RG - With this strategy, the correct configuration of the RG and

its connection to the iMAP device happens when power to the RG is applied. These is the step order listed above. This is

the most common sequence for a new customer.

2. Fill in the Triple Play form after the RGs have been plugged in - With this strategy, the RGs are correctly configured as

the Triple Play form for each port is filled out and then applied, either immediately or on a schedule.

3. Use the new configuration tasks to re-engineer a previously installed RG. This should always be done when the service

“mix” is being changed, and so the relevant Profiles can be associated with the RG. However, even if the services remain

the same, using the AlliedView NMS to reconfigure the RG is recommended, since it incorporates the RG into the same

configuration as new ones. It is recommended that existing RG customers use the AlliedView Bootstrap sequence which

uses DHCP.

Note: Although any of these strategies can be used, strategy one is used in the example installation procedures, where the pre-

provisioned configuration is downloaded to the RG at the end of the DHCP/discovery process.

iMG_7x6_model

- iMG7x6MOD takes HPNA 320 card

= voice_VLAN (VID 10)

= video_VLAN (VID 40)= data_VLAN (VID 20,)

Video

Head

Gateway

Class 5

Switch

ISP

Customer

XE/GE NM card FX10 card

= Physical Link

= IP Subnet

6 LAN Ports

Available

Note 2

Note 1

Video to

Set Top Box

Data to PC

2:1 Media

Converters

Note 1

HPNA Network

4020

FXS FXS

SFP

BD Fiber

Ethernet

HPNA

1 2 ... 631 632 633 634 635 636 637 638 639 640 641 ... 994 995

Comentarios a estos manuales

Sin comentarios

Allied Telesis AT-iMG606BD Especificaciones Pagina 636

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores Allied Telesis AT-iMG606BD