Allied Telesis AT-iMG606BD Especificaciones descargar pdf (Pagina 182)

100

101

173

AlliedView NMS Administration Guide

8. Troubleshooting Policies and Profile Management

8.1 QoS Deployments Table

Since QoS Deployment has interrelationships with profiles and ports, there are some help procedures to understand these

relationships and to use them to troubleshoot problems that may occur.

To view the status of policies, there is the QoS Deployments table, which lists the attributes of the policies and their

deployment status. To access this table select Network Services Data > QoS Deployments, as shown in the following figure.

FIGURE 8-1 QoS Deployment Status

This table is used in many of the procedures below.

8.2 Determine which QoS Policy is Assigned to a Port

1. Locate the port in the Network Inventory -> Ports table.

2. The “Profile” column will indicate which NMS Profile is assigned to the port.

3. If the Profile Name has a “*” after it, then the NMS Profile is out-of-sync with the deployed port parameters. It should be

redeployed to the port so that the port is in-sync with the Profile configuration.

4. Once the NMS Profile is in-sync, locate the Profile in the Network Services -> Profiles table and right-click on the Profile

and select the View Profile item.

5. The “QOS Policy” parameter will show the name of the QoS Policy that has been assigned to the port.

8.3 Determine Whether a QoS Policy is Deployed and In-sync on a

Device

1. Locate the Node (i.e. device) and NMS Policy in the Network Services Data -> QoS Deployments table.

2. If there is not a row for this in the table, then the QoS Policy has not yet been deployed to the device. If so, go to the

Network Services Data -> Profiles table, select/create a Profile that assigns the desired QoS Policy and right-click to deploy the

profile to the desired device.

3. If there is a row in the QoS Deployments table associated with the Policy and device, then verify that the QoS Policy

deployment is in-sync with the QoS components on the device. This is reflected in the Deployment Status column. The

status should show “no_changes”.

4. To re-check that the device policy has not been recently removed, right-click on the deployment row and select Update

Deployment Status. This will cause the NMS to go to the device and verify that the policy is still there.

Caution: QoS components on the device that are associated with an NMS policy should not be edited via CLI. These changes may not

be detected by the NMS, in which case the status will continue to show “no_changes”. For efficiency reasons, the NMS will

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 994 995

Comentarios a estos manuales

Sin comentarios

Allied Telesis AT-iMG606BD Especificaciones Pagina 182

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores Allied Telesis AT-iMG606BD