Allied Telesis AT-iMG606BD Especificaciones descargar pdf (Pagina 436)

100

101

12. Port Management - non-iMAP Devices Dual End Line Testing (DELT)

427

AlliedView NMS Administration Guide

Note: The ability for the iMAP to run DELT is from release 9.0, while the NMS DELT feature is for NMS release 10.0. Therefore,

this NMS feature can be run on an iMAP running a 9.0 load, although there are some additional DELT feature for iMAP 10.0.

12.3.1 Accessing DELT

From the Port Management application select an active ADSL port one of the supported card types. Select the ADSL

Configuration tab, then the Diagnostics tab. If the tab is not present then the port does not support DELT. Then select the

DELT tab, as shown in the following figure. If there is existing data from a previous DELT the fields are populated and the

DELT Graph tab will be active. If there was no previous DELT the DELT Graph tab will be inactive and grayed out.

FIGURE 12-7 DELT Testing Tab

12.3.2 Initiate a DELT Diagnostic

Clicking the Diagnose Interface button will initiate a DELT. A confirmation dialog box appears indicating that service may be

disrupted, if confirmed the ATI activity dialog appears until the test starts. While running, all the buttons are disabled except

for View Exported Test. The “DELT Status” field indicates “Running” or “In Progress” while the test is running. When

successfully completed the basic result values will populate the fields, the DELT Graph tab will be activated, and all the

buttons will be enabled.

12.3.3 Retrieve DELT Results

DELT results are automatically retrieved when the DELT tab is selected, and after a successful DELT test. Clicking the

Refresh Data button will re-retrieve this data, along with the current mode of the port. If the port Mode is unknown, due to

the port retraining after the last test, this will also update that field.

12.3.4 Graph DELT Result

When DELT results exist the DELT Graph tab is activated. Selecting it will display the following screen. Initially all

parameters are in the left window and none are graphed. Selecting one or more and clicking the View Parameter button will

move it into the right “Graphed Parameters” list and draw a graph of its data. The color of the line used is shown next to

1 2 ... 431 432 433 434 435 436 437 438 439 440 441 ... 994 995

Comentarios a estos manuales

Sin comentarios

Allied Telesis AT-iMG606BD Especificaciones Pagina 436

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores Allied Telesis AT-iMG606BD