Allied Telesis AT-BMGMT Guía de instalación Pagina 72

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 168
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 71
Chapter 3: Installing the Chassis in an Equipment Rack
72
Adjusting the Equipment Rack Brackets
You may set the position of the chassis relative to the front of the
equipment rack by adjusting the two equipment rack brackets that are pre-
installed on the sides of the unit. The front of the chassis can be flush with,
extend beyond, or be recessed behind the front of the equipment rack.
You may also install the chassis so that the rear panel is flush with the
front of the equipment rack.
The different bracket positions are listed in Table 18 and illustrated in
Figure 29 on page 73 and Figure 30 on page 73. Please review the
following information before moving the brackets:
Position A, the default position, positions the chassis so that the
front of the unit is flush with the front of the equipment rack.
Position B recesses the front of the chassis by 27.39 mm (1.1 in).
Positions C to E extend the front of the chassis beyond the front of
the rack from 27.39 mm (1.1 in) to 140.85 mm (5.545 in).
Position F installs the chassis with the rear panel flush with the
front of the equipment rack.
To install the rack mount brackets in position “E,” you have to
remove the two chassis screws from the bottom-middle section of
the chassis and re-install them in front where the rack mount
bracket screws were originally, as shown in Figure 29 on page 73.
The dimension (X) between the front panel and the rack rails is
given for each rack mounting bracket position in Table 18.
Table 18. Front Panel to Rack Rail Dimensions
Figure # Front Panel Position
Dimension X
Front Panel to Rack Rail
29 A
(Factory Installed - Flush)
3.69 mm (0.145 in)
29 B
(Recessed)
-27.39 mm (-1.078 in)
29 C 27.39 mm (1.078 in)
29 D 47.71 mm (1.878 in)
29 E 140.85 mm (5.545 in)
30 F
(Reverse Position)
374.16 mm (14.731 in)
Vista de pagina 71
1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 167 168

Comentarios a estos manuales

Sin comentarios