Allied Telesis AT-BMGMT Guía de instalación descargar pdf (Pagina 43)

SwitchBlade x8112 Chassis Switch Installation Guide

SBx STATUS

LEDs

The SBx LINECARD STATUS LEDs display general status information

about the Ethernet line cards and controller cards. There is one LED for

each slot. If the chassis has two controller cards, the SBx Status LEDs on

both cards are active. The LEDs are defined in Table 10 on page 43.

Table 10. SBx LINECARD STATUS LEDs

LEDs State Description

1 to 12

Off Indicates that the slot is empty.

Solid Green Indicates that the Ethernet line or controller

card is operating normally.

Flashing Green Indicates that the card is booting up,

running in test mode, or loading its

configuration settings.

Solid Amber Indicates that the card is in an off-line state.

Possible causes are:

 An Ethernet line card that displays this

LED state may have encountered a

problem initializing the management

software.

 An Ethernet line card that displays this

LED state might not be able to boot up

because the controller card does not

have the appropriate load file and

needs to be updated to the most recent

release of the management software.

 A standby master controller card that

displays this LED state may have been

disabled by the active master controller

card because the cards have

incompatible versions of the

management software and were unable

to resolve the problem, possibly

because of insufficient free flash

memory.

You may remove a line or controller card

from the chassis when it is in this state.

Flashing Amber Indicates that the card is reporting a fault

condition. Use the management commands

to determine the specific problem.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 167 168

Sin comentarios

Allied Telesis AT-BMGMT Guía de instalación Pagina 43