Allied Telesis AT-BMGMT Guía de instalación descargar pdf (Pagina 46)

Chapter 1: Overview

The NET MGMT port has a standard RJ-45 8-pin connector and operates

at 10, 100, or 1000 Mbps in either half- or full-duplex mode. The cable

requirements for this port are the same as the ports on the AT-

SBx81GT24 Line Card, given in Table 1 on page 30. For the port pinouts,

refer to “Connectors and Port Pinouts” on page 167.

The default setting for the port is Auto-Negotiation, which sets the speed

and duplex mode automatically. You may disable Auto-Negotiation and

configure the port manually. The port is referred to as ETH0 in the

management software.

RADIUS client Used for remote management

authentication and 802.1x port-

based network access control.

RMON with SNMP Used with the RMON portion of

the MIB tree on an SNMP

workstation to remotely monitor

the switch.

Secure Shell server Used to remotely manage the

chassis with a Secure Shell client.

SNMPv1 and v2c Used to remotely manage the

chassis with SNMP.

SNTP client Used to set the date and time on

the controller card, from an NTP or

SNTP server on your network or

the Internet.

Syslog client Used to send the event messages

from the controller card to syslog

servers on the network.

TACACS+ client Used with a TACACS+ server on

your network for remote

management authentication.

Telnet server Used to remotely manage the

chassis with a Telnet client.

TFTP client Used to download files to or

upload files from the controller

card with TFTP.

TRACEROUTE Used to determine the

intermediate nodes (or hops) of

network paths.

Table 11. Features that Use the NET MGMT Port (Continued)

Feature Description

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 167 168

Sin comentarios

Allied Telesis AT-BMGMT Guía de instalación Pagina 46