Allied Telesis AT-BMGMT Guía de instalación descargar pdf (Pagina 44)

Chapter 1: Overview

eco-friendly

Button

You may use the eco-friendly button on the controller card to turn the

LEDs on or off. You may turn off the LEDs when you are not using them to

monitor the control and Ethernet line cards, to conserve electricity. When

the LEDs are off, the overall power consumption of the chassis is slightly

reduced, approximately 3 watts in a system with 240 active copper ports.

The button controls all of the port LEDs on the Ethernet line cards and

controller card, except for the CFC LED, which is always on, and the L/A

LED for the NET MGMT port. The button does not control the LEDs on the

fan module and power supply systems.

Reset Button You may use the Reset button to reset either the controller card or all of

the cards in the chassis. The action depends on the number of AT-

SBx81CFC400 Controller Cards in the chassis and, if the chassis has two

controller cards, whether you reset the active or standby master controller

card.

The possible actions are described here:

 If the chassis has only one controller card, pressing the Reset

button resets the controller card and all of the Ethernet line cards in

the chassis. You may perform this function if the chassis and line

cards are experiencing a problem.

Caution

The control and Ethernet line cards do not forward network traffic for

a minimum of two minutes while they initialize their management

software and configure their parameter settings. Some network

traffic may be lost.

 If the chassis has two controller cards, pressing the Reset button

on the active master controller card resets the controller card, but

not the Ethernet line cards. The standby master controller card

immediately becomes the new active master card and the Ethernet

line cards continue to forward traffic. The reset controller card is

unavailable for about two minutes while it initializes its

management software, after which it becomes the standby master

controller card in the chassis.

Note

The available bandwidth across the backplane of the chassis is

reduced from 800 to 400 Gbps for about one minute while the reset

controller card initializes its management software. This may reduce

network performance.

 If the chassis has two controller cards, pressing the Reset button

on the standby master controller card resets that card, but not the

active master controller card or the Ethernet line cards.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 167 168

Comentarios a estos manuales

Sin comentarios

Allied Telesis AT-BMGMT Guía de instalación Pagina 44

Comentarios a estos manuales

Relacionado con productos y manuales para Los conmutadores de red Allied Telesis AT-BMGMT