Allied Telesis AT-iMG7x6MOD series Manual de instalación descargar pdf (Pagina 33)

AT-iMG646MOD Installation Guide

Chapter 4: Installing the Gateway Indoors 33

Connecting the Power Cord

The AT-iMGxx6MOD gateways are designed to be deployed with an uninterrupted power supply (UPS). You

can purchase a UPS from Allied Telesis (part number AT-iMG008/AT-iMG008G). Install the power supply

according to the manufacturer’s instructions included in the package.

Allied Telesis provides a 15 ft. power cable (part number AT-iMG646MOD-C01). Alternatively, you can

make custom length power cables. The terminal adapters are supplied with the AT-iMG008/AT-iMG008G

UPS and the gateways. For lengths up to 50 ft., use three pair twisted wire with a minimum 18 AWG. Figure

32 on page 49 provides a detailed wiring diagram.

To connect the power cord, perform the following procedure:

Warning

Ensure that the APC power supply is OFF before you perform this procedure.

1. Connect the wires in the power cord to the DC terminal block in the accessory kit (the wiring diagram is

shown in Appendix A) at 4.5 in-lbs. Or, use the Allied Telesis power cord, model AT-iMG646MOD-C01

(not provided).

2. Plug the terminal block into the DC power socket, as shown in Figure 22.

Figure 22. Plugging in the DC Terminal Block

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 55 56

Sin comentarios

Allied Telesis AT-iMG7x6MOD series Manual de instalación Pagina 33