Allied Telesis AT-iMG7x6MOD series Manual de instalación descargar pdf (Pagina 29)

AT-iMG646MOD Installation Guide

Chapter 4: Installing the Gateway Indoors 29

Mount the Grounding Stud

1. Put the included #8-32 x 0.5 in. SEMS screw through the right chassis grounding hole in the chassis, as

shown in Figure 17

2. Secure the screw with a #8-32 Kepnut (not provided), as shown in Figure 17.

Figure 17. Mounting the Grounding Assembly on the Right Mounting Hole

(Note: Instead of the #8-32 Kepnut, you can also use a #8 nut with a lock washer.)

Fastening the Plywood Mounting Surface to a Wall

For an indoor installation, the AT-iMG646MOD series intelligent Multiservice Gateway must be mounted on

a plywood surface that complies with the following specifications:

 Recommended minimum size of 12 in. by 12 in. (31 cm by 31 cm)

 Recommended minimum thickness of 0.5 in. (1.2 cm)

 Rated for indoor use. Medium density fiberboard (MDF) is not recommended.

To fasten the plywood to the wall, perform the following procedure:

1. Select a reasonably flat wall location

2. Using a 3/16 in. (4.5 mm) wood or metal drill bit, drill a hole through each corner of the plywood (only),

approximately 1 in. (2.5 cm) from the edge.

3. Using the plywood as a template, mark the location for the holes on the wall.

4. Using a 3/16 in. (4.5 cm) of the appropriate type drill bit, drill the four holes in the wall at least 1in. (2.5

cm) deep.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 55 56

Sin comentarios

Allied Telesis AT-iMG7x6MOD series Manual de instalación Pagina 29