Allied Telesis AT-iMG7x6MOD series Manual de instalación descargar pdf (Pagina 24)

AT-iMG746MOD Installation Guide

24 Chapter 3: Installing the Gateway in the Enclosure

Connecting the LAN Cables

To connect the LAN cables, perform the following procedure:

1. Remove the grommet from the LAN cable entrance. (This step has already been done if you have

installed the phone cable.)

Note

Allied Telesis recommends that you fully wire all six ports to allow for easy service expansion in the

future.

2. Insert a UV-rated wire tie through the slots at the bottom of the entrance.

3. Connect the LAN cables to the RJ-45 ports on the gateway.

4. Secure the wires with a wire tie, as shown in Figure 15. (This step will include the telephone wires if you

have installed the phone wires.)

Figure 15. Connecting the LAN Cables (Phone lines omitted for clarity)

5. Cut a notch into the bottom of the grommet to accommodate the LAN cables (and telephone cable if it

has been installed) and reinsert the grommet.

6. Trim the wire tie and seal the grommet with tape and silicone sealant.

Caution

The grommet must be sealed so that the unit can operate correctly in an outside environment.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 55 56

Sin comentarios

Allied Telesis AT-iMG7x6MOD series Manual de instalación Pagina 24