Allied-telesis AT-S63 Manual de usuario descargar pdf (Pagina 150)

100

101

Chapter 11: File System Commands

150

SET CONFIG

Syntax

set config="

filename

.cfg"

Parameter

config Specifies the name of the configuration file to act as

the active configuration file for the switch. The name

can be from 1 to 15 alphanumeric characters, not

including the extension “.cfg”. If the filename contains

spaces, it must be enclosed in double quotes.

Description

This command sets the active configuration file for a switch. The switch

uses the active configuration file to configure its parameter settings the

next time it is rebooted or power cycled.

To view the name of the currently active configuration file, see “SHOW

CONFIG” on page 58.

You can specify a configuration file that already exists in the switch’s file

system, or one that does not. To view the configuration files already in a

switch’s file system, see “SHOW FILE” on page 152. Configuration files

have a “.cfg” extension.

Selecting a new active boot configuration file does not change the

current configuration of the switch. If you want the switch to reconfigure

itself according to the configuration in the newly assigned active boot

configuration file, reset or power cycle the switch.

You do not need to use the SAVE CONFIGURATION command when you

change the designated active configuration file. The change is

automatically saved to permanent memory.

If you specify a nonexistent configuration file, the switch creates the file

after you use the SAVE CONFIGURATION command.

Note

The active boot configuration file is updated whenever you use the

SAVE CONFIGURATION command.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 463 464

Comentarios a estos manuales

Sin comentarios

Allied-telesis AT-S63 Manual de usuario Pagina 150

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Allied-telesis AT-S63